Robert Axle Project

Trainer 12mm Thru Axle, 159 or 165mm Thread: 1.5mm

Robert Axle Project thru axles allow modern frames to be used with axle mount trainers.

• Application: Bike trainers
• Axle shaft and axle ends are machined from 7075 aluminum and hard anodized
• Designed, built and tested in the USA
• For use with bike trainers such as 1up, Blackburn, Cyclops, Kinetic, Tacx and more
• IMPORTANT: Before ordering, make sure your specific trainer will accommodate the width of the thru-axle equipped bike that you are using
• Installed or removed using a 5mm Allen wrench
• Materials: 7075 Aluminum
• Measure trainer at the widest setting and measure the bike frame width at the rear hub
• The Robert Axle ends will extend 15mm past the frame on each side